Greenheck Hooded Propeller Fans Exhaust and Supply (455601) User Manual
Assembly instructions, Exhaust and supply, Step 1: unpack and inspect parts parts list
1
Model
1
Hooded Propeller Roof Fans • Exhaust and Supply
Assembly Instructions
Please read these instructions carefully before attempting to assemble the product described. Protect
yourself and others by observing all safety information. Failure to comply with instructions could result
in personal injury and/or property damage!
®
PN 455601
Hooded Propeller Roof Fans
Exhaust and Supply
Step 1: Unpack and Inspect Parts
Parts List
Exhaust / Supply Fans
Fan Size / Quantity of Parts per Fan Size
Parts Description
18 20 24 30 36 42 48 54 60 72
Fan / Base Assembly
1
1
1
1
1
1
1
1
1
1
Hood Support Rail Assembly
2
2
2
2
2
2
2
2
2
2
Side Birdscreens (Long Screens) 2
2
2
2
2
2
2
2
2
2
Side Birdscreens (Short Screens) 2
2
2
2
2
2
2
2
2
2
Hood Rails
2
2
2
2
2
2
2
2
2
2
Hood Panels including 1 Male &
1 Female hood enclosure panel
4
4
5
6
7
8
9
9
10 11
Hood Clips for sizes 54 - 72
–
–
–
–
–
–
–
16 18 20
Shaded sizes will always ship fully assembled unless otherwise specified.
Tools required to assemble fans:
• Battery Drill, Electric or Pneumatic preferred.
• 3/8”, 7/16”, 1/2”, and 9/16” Wrenches and Sockets.
• 5/16” Nut Runner Bit for Drill.
• Rubber Mallet.
• Awl for Hole Alignment.
IMPORTANT!
It is recommended that a two man
crew minimum be used for fan/
hood assembly.
Hood
Enclosure
Panel
(Female)
Hood
Support
Rail
Long Birdscreen
Section
Short Birdscreen
Section
Hood
Panels
Hood Clips
(Sizes 54 - 72)
Hood Enclosure Panel
(Male)
Label
Each fan that is shipped knocked down has the
following hardware package containing:
Part # 816529 - Hardware Package
Part # 816526 - Hood Support Fasteners
(16) 3/8” - 16 x 3/4” Spinlock Bolts
(12) 3/8” - 16 Spinlock Nuts
Part # 816527 - Hood Fasteners
(75) #12 x 3/8” Sheet Metal Screws with Washer
(4) 3/8” - 16 x 1-1/2” Spinlock Bolts
(4) 3/8” - 16 Spinlock Nuts
Part # 816528 - Birdscreen / Filter Fasteners
(26) 5/16” - 18 x 3/4” Weld Stud Bolts
(26) 5/16” - 18 Spinlock Nuts
(4) #12 x 3/4” Self-Drilling Screws w/ Washer
Note: Hardware package is designed for the filtered 72” fan.
When used on smaller sizes, there will be some fasteners
left over.
Hood
Rail