Hypertherm D845GEBV2 - Manual (Page 103)

BIOS Setup Program
103
4.4.4 IDE Configuration Submenu
To access this submenu, select Advanced on the menu bar and then IDE Configuration.
Maintenance Main Advanced Security Power Boot Exit
PCI Configuration
Boot Configuration
Peripheral Configuration
IDE Configuration
Diskette Configuration
Event Log Configuration
Video Configuration
USB Configuration
Chipset Configuration
Fan Control Configuration
The menu represented in Table 59 is used to configure IDE device options.
Table 59. IDE Configuration Submenu
Feature Options Description
IDE Controller
• Disabled
• Primary
• Secondary
• Both (default)
Specifies the integrated IDE controller.
Primary enables only the primary IDE controller.
Secondary enables only the secondary IDE controller.
Both enables both IDE controllers.
PCI IDE Bus Master • Disabled
• Enabled (default) Enables/disables the use of DMA for hard drive BIOS
INT13 reads and writes.
Hard Disk Pre-Delay • Disabled (default)
• 3 Seconds
• 6 Seconds
• 9 Seconds
• 12 Seconds
• 15 Seconds
• 21 Seconds
• 30 Seconds Specifies the hard disk drive pre-delay.
Primary IDE Master Select to display
sub-menu Reports type of connected IDE device.
Primary IDE Slave Select to display
sub-menu Reports type of connected IDE device.
Secondary IDE Master Select to display
sub-menu Reports type of connected IDE device.
Secondary IDE Slave Select to display
sub-menu Reports type of connected IDE device.