Datalogic Scanning Rhino-NET 40012 - Manual (Page 38)

RHINO-NET™
3
Scan Timeout: the maximum time, in milliseconds, during which Rhino-NET™ accepts data
from the port after a Soft Trigger.
Beep Duration: not applicable to Rhino-NET™.
Beep Frequency: not applicable to Rhino-NET™.
LED Duration: not applicable to Rhino-NET™.
LED Pulses: not applicable to Rhino-NET™.
Continuous Mode: when enabled, Rhino-NET™ always accepts data on the port if Scan
Always On is enabled. Continuous Mode overrides Scan Timeout.
Keyboard Emulation: if enabled all scanned data are transformed into keyboard events and
can therefore be displayed and saved to a file as if input from the terminal keyboard.
Soft Trigger: when enabled, gives control of Rhino-NET™ data reception to the application
software.
Scan Always On: enables the Rhino-NET™ data reception independently from the
application software.
Default Settings
The following tables contain the default values for the major scanner setup parameters,
according to the type of scan engine mounted on the peripheral device connected to the
terminal. For a complete list of parameters and of their configuration procedures, please refer
to the SDK Help file on the CD-ROM.
READER PARAMETERS VALUES
Port Serial
Baudrate 9600
Frame Rate
8
Stop Bits 1
Parity none
Read Timeout (ms)
100
SCAN PARAMETERS VALUES
Scan Timeout 5000
Beep Duration 20
Beep Frequency 2000
LED Duration 0
LED Pulses 0
Continuous Mode Disabled
Keyboard Emulation Enabled
Soft Trigger Enabled
Scan Always On Disabled
24