Leprecon LPC V3 User's Manual - Manual (Page 37)

LPC 48 / 96 Users Manual
Page 37
4 Stage View - Manual Channels
The LPC allows manual channel control using front panel faders. Channels
beyond the fader range are set using the video interface or keypad, and are
referred to as Virtual Channels.
The Manual Fader on the left side of the fader banks controls the output of the
desk channel faders. Getting output from the manual scene requires the Grand
Master and the Manual fader to be up. LPC must be in Run Mode to see Stage
view. Submaster Run and Cue Run controls and features are similar.
4.1 Using Channel Faders
Operation of the desk channel faders are chosen in the Settings screen, (see
section 3.3.1.) The desired use of the desk faders is selected by either Wide
Mode or Two Scene Preset Mode. The Fader Mode key, located above the
manual fader, is a secondary control of the operation, (See Figure 18).
The two banks of faders can be used in the following ways:
Wide Mode
Fader Mode – Manual: all desk channel faders are used as a single scene.
The manual fader has control over the desk and virtual channel output.
Fader Mode – Subs: the lower bank faders are Submasters only, and the
manual fader does not affect their output. The upper bank and virtual channel
outputs are controlled by the manual fader.
Two Scene Preset Mode
Fader Mode – Manual: upper and lower bank of desk channel faders are set
as two separate scenes. The manual fader is used to crossfade between the
two scenes, and the virtual channels are not affected.
Fader Mode – Subs: the bottom faders are Submasters only and the manual
fader does not affect their output. The manual fader has control over the