Leprecon LPC V3 User's Manual - Manual (Page 95)

LPC 48 / 96 Users Manual
Page 95
• Select a label to set all selected fixtures to a new value. If new labels are
needed, use available attributes to create a new label. See the section 10.3.2
regarding label creation.
10.3.5 Set Position
Moving mirror and moving head fixtures can be programmed to light specific
areas. The Position tab in LPC Details is used to set all attributes related to
positioning a fixture.
Position labels are different from Color and Beam lables in two important ways:
1 ) To illuminate the same spot on stage, the Pan and Tilt values are different for
each fixture. The user must create focus positions for each fixture before
programming.
2) For this reason, there are no pre-defined ‘Position’ labels in the LPC software.