LSC Lighting GenVI - Manual (Page 21)

GenVI Dimmer Menu System
Operator Manual V1.0
Page 17
 Pressing DMX will take a snapshot of the current DMX input signal.
 Pressing Outputs will take a snapshot of the current output of the GenVI. These
channel levels could be coming from DMX or Riggers Control or a combination of
both.
When you take the snap, the channels levels will be displayed in the box.
To save the snapshot to the memory press Apply.
The channels levels that were captured in the snapshot can be edited by manually setting
channel levels as described above.
3.8.3.3 Fade Time
When editing the DMX Loss memory (above), you can set a fade (in/out) time for the memory
by pressing Fade.
Enter a time in seconds (0 to 99.99) then press Apply.
3.8.3.4 Fade In/Out
The DMX Loss memory is normally activated automatically when DMX is lost but you can
also manually fade the memory in or out using the Fade In / Fade Out button.
Channel levels in
the snapshot