Marantz SR6001 - Manual (Page 20)

ENGLISH
17
CONNECTIONS
SPEAKER PLACEMENT
The ideal surround speaker system for this unit is 7-
speaker systems, using front left and right speakers,
a center speaker, surround left and right speakers,
a surround back left and right speakers, and a
subwoofer.
For best results we recommend that all front speakers
be of the same type, with identical or similar driver
units. This will deliver smooth pans across the front
sound stage as the action moves from side to side.
Your center channel speaker is very important as
over 80 % of the dialog from a typical motion picture
emanates from the center channel.
It should possess similar sonic characteristics to the
main speakers. Surround channel speakers need not
be identical to the front channel speakers, but they
should be of high quality.
The surround center speaker is useful for playback
of Dolby Digital Surround EX or DTS-ES. One of
the benefi ts of both Dolby Digital and DTS is that
surround channels are discrete full range, while they
were frequency limited in earlier “Pro Logic” type
systems.
Bass effects are an important part of home theater.
For optimal enjoyment a subwoofer should be used
as it is optimized for low frequency reproduction. If
you have full range front speakers, however, they
may be used in place of a subwoofer with proper
setting of the switches in the menu system.
90 ° 110 °
22 °
30 °
135 °
150 °
0 °
Front left and right speakers
We recommend to set the front L and R speakers
with 45-60 degrees from the listening position.
Center speaker
Align the front line of the center speaker with the front
L/R speakers. Or place the center speaker a little
backward from the line.
Surround left and right speakers
When the SR6001 is used in surround operation,
the preferred location for surround speakers is on
the side walls of the room, at or slightly behind the
listening position.
The center of the speaker should face into the
room.
Surround back left and right speakers
Surround back speakers are required when a full 7.1-
channel system is installed.
Speakers should be placed on a rear wall, behind the
listening position.
The center of the speaker should face into the
room.
Subwoofer
We recommend using a sub-woofer to have maximum
bass effect. Sub-woofer bears only low frequency range
so you can place it any where in the room.
HEIGHT OF THE SPEAKER UNITS
Front left and right speakers, and a center speaker
Align the tweeters and mid-range drivers on the
three front speakers at the same height, as best as
possible.
Surround left and right speakers, and surround
back speaker
Place the surround left, right and surround back
speakers higher than your ears by about 70cm–1m.
Also place the speakers at the same height, as best
as possible.
70cm
1m
Note:
• Use magnetically-shielded speakers for front left,
right and the center speakers when the speakers are
installed near the TV and the TV is a monitor type.
CONNECTING SPEAKERS
FM (75) GND AM
DC OUT
OUTPUT
COMPONENT VIDEO
IN OUT
PRE
OUT
SL L
R SR
FLASHER IN
SPEAKER
SYSTEMS
INPUT 1(DVD)
COAX.
DIGITAL IN DIGITAL OUT
3
5 4
2 1
SURROUND BACK
OUT
R
OUT
L
RS-232C
OUTPUT
TAPE CD/CD-R
OUT OUT IN
MULTI
R
L
DSS
(AUX2) AUDIO
TV
7.1CH IN
IN
OPT.
DVD(2) DSS(4) TV(1)
VIDEO
OUT
VCR(3) OUT IN
RC-5 MULTI RC
INPUT 1(TV)
INPUT 4(DSS)
IN
SR
VCR
IN
INPUT 3(VCR)
DVD SL
INPUT 2(DSS)
ANTENNA
CB/PB CR/PR CR/PR CR/PR CB/PB CB/PB Y Y Y
DVD(2) DSS(4) VCR(3) TV(1) MONI. OUT MONITOR OUT
SBR
SBL
SBR
SBL
C
SW
SW
C
R
L
R
R
R
L
L L
AC IN
INPUT 2(DVD)
S-VIDEO
MODEL NO. SR6001
FRONT B
SURR
OUND
CEN
TER
FRONT A
ON
OFF
MULTI SPEAKER / SPEAKER C
FRONT A OR B.CENTER.SURR.
SURR BACK : 6 - 8 OHMS
FRONT A + B : 8 OHMS
HDMI
Ver1.2
UNSWITCHED 1.25A 150W
SWITCHED
1.25A 150W
AC OUTLETS 120V 60Hz
XM
INVERT
OUTPUT INPUT
LEVEL BTL REMOTE CONT. EXT. CONT. IN
VIDEO/ +5~13V DC SYSTEM OUT OUT
INPUT MASTER SLAVE MIN MAX IN
FU S E
SPEAKER SYSTEM
MINIMUM 4 OHMS
Powered
subwoofer Power
Amplifi er
Passive
subwoofer
Surround
Right Left
FRONT A
Surround
BACK
Center
Right Left
CONNECTING SPEAKER WIRE
1. Strip away approx. 3/8 inch (10 mm) of wire
insulation.
2. Twist the bared wire ends tight, to prevent short
circuits.
3. Loosen the knob by turning it counterclockwise.
4. Insert the bare part of the wire into the hole in
side of each terminal.
5. Tighten the knob by turning it clockwise to
secure the wire.
1. 2.
3. 4. 5.
3/8 inch
(10 mm)
Front Right
Front Left
Front Center
Surround Left
Subwoofer
Surround Back
Left
Surround Right
Surround Back
Right
Right Left
FRONT B
Right Left
SR6001U DFU_1_ENG 1_4.indd 17 SR6001U DFU_1_ENG 1_4.indd 17 06.12.21 4:14:02 PM 06.12.21 4:14:02 PM