Microcom 428T - Manual (Page 133)

Chapter 5 Printer Commands
428T Operator’s Manual - 880037-0140 5-59
Label FORMATS stored in user FLASH memory are NOT erased by this
command. Use the ^D131 command to erase label FORMATS stored in
FLASH memory.
IMPORTANT NOTE!!! Embedded FONTS and label FORMATS are NOT
erased. However, any custom FONTS and GRAPHICS loaded into user
FLASH memory at the factory WILL be erased.
Hint: After the user FLASH has been deleted, the ^D119 command may be
used to verify that Slots #1 thru #255 are now available in FLASH.
141 Clear User GRAPHIC and FONT FLASH & RAM memory.
This command clears all user FONTS and GRAPHICS in FLASH memory, and
all the downloaded FONTS and GRAPHICS in RAM. This command is the
equivalent to sending:
1) ^D100 (clears all downloaded FORMATS, FONTS and GRAPHICS
in RAM.
2) ^A0^D140 (clears all user FONTS and GRAPHICS in FLASH).
Label FORMATS stored in user FLASH memory are NOT erased by this
command. Use the ^D131 command to erase label FORMATS stored in
FLASH memory.
Please note that this command may take some time (depending on how much
is stored). During this time the printer will not respond to commands. The
printer may appear to be locked up until the command finishes.
Hint: Use command ^D119 to confirm that FONTS and GRAPHICS were erased in
user FLASH memory, and that all downloaded FORMATS, FONTS, and
GRAPHICS were erased in RAM.
5.13 Printer Code Update
^A ^D COMMAND
X 7 Update Printer Code:
This command is used to update the printer’s flash memory in the event new
or enhanced features exist in a different software version. Sending a
^A62519^D7 command will update the printer’s bootloader, application, and
embedded font set. This process requires some interactivity with the printer
and failure to follow the proper process will cause the printer to become
inoperable. Please contact your Microcom Corporation Representative for
more information.
5.14 Miscellaneous Commands
^A ^D Command
5 Send Printer Status: (Equivalent ^E)
X 93 Load Control Code Recognition Status:
0 Enable control code recognition
1 Disable control code recognition