Microcom 428T - Manual (Page 231)

428T Operator’s Manual - 880037-0141 13-11
^A ^D COMMAND
XX 42 Load Label Width in dots (LSX): The ^Axx specifies the value.
XX
43 Load Label Height in dots (LSY): The ^Axx specifies the value.
XX
44 Load the Web Size in dots (WEB): The ^Axx specifies the value.
XX
45 Load the Gap Size in dots (GAP): The ^Axx specifies the value.
XX
46 Load Print Speed: The ^Axx specifies the value. Uses the same values as
the DPS header value; 0 to 13.
XX
47 Load the Label Control Byte (LCB): The ^Axx specifies the value.
XX
48 Load the Number of Steps to Activate Gap Detector (AGD): The ^Axx
specifies the value in Dot Rows.
XX
49 Load the Number of Steps Past Gap (SPG): The ^Axx specifies the value in
Dot Rows.
XX
50 Load X Direction Offset (OFX): The ^Axx specifies the value.
XX
51 Load Y Direction Offset (OFY): The ^Axx specifies the value.
XX
54 Send Format from RAM to the Port: The ^Axx specifies the slot number
where the format file is stored in RAM. Valid values for Axx are A1 to A128.
XX
55 Select Default Power-up Format: Selects the ROM power-up format. The
^Axx selects from the available formats 1 through 8.
56 Select User Defined Layout: Signals the end of the label field definition.
57 Enter Label Format Mode: Instructs the printer that information for a format
is following the command.
XX
58 Process Format Saved in RAM: The ^Axx selects which stored format to
process (1-128). This command takes the selected format in RAM and makes
it into a label.
XX
59 Save Formats to RAM. (1 - 128)
60 Clears Command 61
XX
61 Mark Text Starting Position: The ^Axx designates which text field to start
entering new data.
62 Pre-Padded Text: This command is sent after the text that is to appear at the
beginning of each field.