Microcom 428T - Manual (Page 151)

Chapter 7 Downloadable Fonts
428T Operator’s Manual - 880037-0141 7-7
^A ^D COMMAND
100 Clear User RAM:
This command clears all downloadable fonts, graphics, and stored label
formats.
101 List Memory Bytes Available:
The printer will send the “>” character followed by the amount of available
bytes and then finally a “<” character. (i.e. >192690<)
XX
104 Load GRAPHIC or FONT into RAM Memory without Compression:
The ^Axx specifies which memory slot to place the image/font (1-255). This
command should be used with an ASCII-HEX file that contains only printable
characters less than 80 HEX. This command supports GRAPHICS over
64KB.
XX
106 Load GRAPHIC or FONT into RAM Memory without Compression:
This command is intended for legacy support only and Microcom Corporation
recommends either the ^D104 or ^D107 commands. Fonts must be less than
64KB for this command to function.
XX
127 Save FONTS to RAM.
(See Section 7.4.1.1)
XX
135 Save a FONT to FLASH.
(See Section 7.4.1.2)