Microcom 412 - Manual (Page 16)

Basic Operation Chapter 2
412 Operators Manual 8
parameters (not the default parameters caused by executing creating a status label), and the
revision number of the firmware.
The switch bank settings reflect the contents of the four software dip switches that configure
the operation of the printer. See section 5.3, specifically ^D21, ^D22, ^D23, and ^D24, for more
information on software dip switch settings.
PRINTER SERIAL #: 1234567890
PRINTED LABELS: 8432
TOTAL LABELS: 8498
PRINTED INCHES: 25296
TOTAL INCHES: 25494
POWER ON HOURS: 897
SWITCH BANK 1: 10001011
SWITCH BANK 2: 01010000
SWITCH BANK 3: 00000010
SWITCH BANK 4: 00000000
SERIAL PARAMETERS: 9600-N-8-1
EXTRA RAM: YES
ADDRESS: 0
NETWORK: OFF
412 REV 02.14 070199-0214 06/24/99
Status Label
Figure 4
2.3.3 PAPER-OUT MODE
When a paper out condition occurs, the red error indicator will light. Once the new labels are
loaded, quickly press and release the front panel button to print a duplicate of the last label
printed. This label can be repeated until proper registration occurs. To return to the pre-paper
out condition, tap the button while the duplicate label is being printed. The red error light
should go out and normal printing may resume.