Microcom 412 - Manual (Page 17)

Chapter 2 Basic Operation
412 Operators Manual 9
2.4 THE STATUS LIGHT
The status lights have different functions depending upon the mode of the printer. The
following table explains the meanings.
Status Light
Color Meaning
Solid Green Power is on.
Flashing Green
during Download
Font or graphic file transferring successfully.
Flashing Red
during Download
Font or graphic file transfer is failing.
Solid Red
Printer error: Possibly caused by paper-out, ribbon-out, take-
up full, or hardware failure. If an unexplained condition
persists, contact your service representative.
Continuous
Flashing Red
Spike or low voltage on the AC line. The unit will remain in this
mode until the condition is removed and the printer is powered
off.
Solid Yellow Printer is paused.
Table 1
2.5 LOADING PAPER
The 412 can dispense labels in a many different ways. The following two sections explain the
dispensing modes. If narrow stock is used (3.5 inches wide or less), it may be necessary to
adjust the print head support screw (see section 2.6).
Thermal Transfer Note:
The 412 will, on power-up, automatically sense a loaded ribbon and select thermal transfer
mode. Please note that the printer will not select thermal transfer mode if the ribbon is loaded
after the printer is turned on. To correct the situation simply cycle the power once the ribbon
has been loaded.