Microcom 412 - Manual (Page 33)

Chapter 4 Designing Labels Using LDS
412 Operators Manual 25
4.4.1 A SAMPLE SESSION (HEADER)
This is the label header from the sample label in section 4.3.
5,812,1218,,20,35 
5 - 5 fields following the header
812 - Label width (LSX) of 812 (812/203 = 4 inches).
1218 - Label length (LSY) of 1218 (1218/203 = 6 inches).
- The WEB parameter can be defaulted.
20 - A GAP between labels of 20 (20/203 = 0.10 inch).
35 - Label print speed (DPS) of 35 = 2 inches per second
(from Table 3)
- No entry for the LCB parameter means default value of
0, normal stock on backing paper.
- The AGD could be defaulted. This value was confirmed
using the auto-size command.
- SPG could be defaulted. This value was confirmed using
the auto-size function.
 - A carriage return must follow the label header. There were
some parameters left that were not entered into the header -
OFX and OFY. Because they were not entered, the printer
assumes the default values, 0 in their cases. Likewise, since
the AGD and SPG were defaulted, the carriage return could
have followed the DPS.
Note: Defaulted fields must be separated by commas and ending commas may
be omitted.