Microsens MS453522M - Manual (Page 98)

MICROSENS 8 Port Gigabit Ethernet Switch User’s Manual
93
Function name:
GVRP Config
Function description:
In the function of GVRP Config, it is used to configure each port’s GVRP operation mode, in
which there are seven parameters needed to be configured described below.
Parameter description:
GVRP State Setting:
This function is simply to let you enable or disable GVRP function. You can pull down
the list and click the <Downward> arrow key to choose “Enable” or “Disable”. Then,
click the <Apply> button, the system will take effect immediately.
Join Time:
Used to declare the Join Time in unit of centisecond. Valid time range: 20 –100
centisecond, Default: 20 centisecond.
Leave Time:
Used to declare the Leave Time in unit of centisecond. Valid time range: 60 –300
centisecond, Default: 60 centisecond.
Leave All Time:
A time period for announcement that all registered device is going to be de-
registered. If someone still issues a new join, then a registration will be kept in the
switch. Valid range: 1000-5000 unit time, Default: 1000 unit time.
Default Applicant Mode:
The mode here means the type of participant. There are two modes, normal
participant and non-participant, provided for the user’s choice.
Normal:
It is Normal Participant. In this mode, the switch participates normally in
GARP protocol exchanges. The default setting is Normal.
Non-Participant:
It is Non-Participant. In this mode, the switch does not send or reply any
GARP messages. It just listens messages and reacts for the received GVRP
BPDU.
Default Registrar Mode:
The mode here means the type of Registrar. There are three types of parameters for
registrar administrative control value, normal registrar, fixed registrar and forbidden
registrar, provided for the user’s choice.