Nevion FR-2RU-10-2 - Manual (Page 11)

FR-2RU-10-2 Rev. N
nevion.com | 11
5 Sub-rack operation
In order to reconfigure or expand the number of modules within a sub-rack, the front
panel must be removed. Each module has a corresponding connector module at the
rear, and is hot swappable.
Use safety goggles when hot-swapping module cards.
If a receiver card is removed from the sub-rack, an invisible laser beam
may be emitted inside the sub-rack from the laser at the other end. The
laser beam might be harmful to your eyes.
5.1 Removing the front panel
Detach the front panel by putting your fingers on the right hand side of the front panel
and pull gently, as shown in the figures below. Then pull the front panel slightly to the
right before removing it.
Hold here Pull here
"Left circle" "Right circle"
Figure 7: Removing the front panel.
A more detailed description of how the front panel is detached is given in figure 8.
Step 1 looks at the details in the "right circle" seen from the right hand side, whereas
the next two steps (step 2 and step 3) gives the details of the "left circle" as seen from
the top.