Nevion FRS-HD-CHO User Manual
Page 5
FRS-HD-CHO
Rev. 9
nevion.com | 5
If one (or both) of these two lines is not present, or the HW version is reported as 1.0, or the
serial number reported is
“XXXXXXXXXXXXXXXX” (literally sixteen X characters), the
module cannot be field upgraded from the FRS-HD-CHO to the FRS-HD-CHO-ASI version.
Of course, the module can still be upgraded with the latest firmware and continue to work as
an FRS-HD-CHO.
1.1.2 Key features
Passive bypass from both inputs to non-inverted outputs with less than 25m loss of cable
length (enables full redundancy, see app. note in appendix)
HD/SD video support, including DVB-ASI in through mode
Separate ASI mode available (as an upgrade from
the „normal‟ FRS-HD-CHO)
Separate ASI-only version available with a much simplified user interface
De-glitching of input video signal (always seamless output)
Intelligent change-over functionality with switching criteria:
Video integrity check
Audio integrity check
Video freeze detect (full frame or active area)
Video black detect (with adjustable black threshold)
Time code freeze
Audio silence detect (with adjustable silence threshold)
Latched switching
Ripple rejection latching with adjustable hold times
Switching between inputs on switching line
GPI inputs for external control of switch
Individual detection timings for video signal integrity, audio signal integrity, video
content and audio content.
HD/SD frame sync/delay (8 frames max)
luma/chroma gain and level adjustment
Audio delay enabling Dolby-E processing delay correction
Audio router for embedded audio
Embedded audio gain adjustment
Audio fade out/fade in at switching or frame-wrap
SDI Label inserter
EDH processing