Desa FPVF33NRA - Manual (Page 18)

www.desatech.com 113109-01D 18
O F
F
P ILO T O N
H I
L O
INSTALLATION
Continued
Figure 28 - Installing Log Set
Figure 29 - Installing Log Set, Top View
Notches
Figure 30 - Installing Fireplace Screen
Screws for
Mounting Screen
Log Set
Chassis
Crossover
Log #3
Burner
Front
Log #
Burner Ports
Back
Log #1
Grate
Prongs
WARNING: After installa-
tion and periodically thereafter,
check to ensure that no flame
comes in contact with any log.
With the heater set to High, check
to see if flame contact any log. If
so, reposition logs according to
the log installation instructions
in this manual. Flames contact-
ing logs will create soot.
It is very important to install the logs exactly
as instructed. Do not modify logs. Only use
logs supplied with fireplace.
vYGF Models Only
1. Place back log #1 on grate to fit as il-
lustrated in Figure 8. Make sure middle
section at bottom of log set is seated into
“U”-shaped cutout in center of chassis
(see Figure 8). IMPORTANT: Make sure
log does not cover any burner ports (see
Figure 9).
. Place front log # against front grate
prongs as shown in Figure 8.
3. Place crossover log #3 on top of front and
back logs as shown in Figure 8.
4. Install fireplace screen by slipping notches
of fireplace screen over screws on front
of fireplace (see Figure 30).
FpvF Models Only
1. Place one-piece log set on grate to fit as
illustrated in Figure 31, page 19. Make
sure middle section at bottom of log set is
seated into “U”-shaped cutout in center of
chassis (see Figure 31, page 19). IMPOR-
TANT: Make sure log does not cover any
burner ports (see Figure 32, page 19).
2. Install fireplace screen by slipping notches
of fireplace screen over screws on front
of fireplace (see Figure 30).
WARNING: You must operate
this fireplace with the fireplace
screen in place. Make sure fire-
place screen is in place before
running fireplace.
WARNING: You must operate
this fireplace with the fireplace
screen in place. Make sure fire-
place screen is in place before
running fireplace.