Quantum Composers 9250 Series - Manual (Page 36)

9250 Manual Version 1.2 | Quantum Composers
36
To start the pulses use either of the following commands:
:PULSE0:STATE ON <cr> <lf> starts the pulses
:INST:STATE ON <cr> <lf> alternate form to start pulses
Example 2)
25μs pulse width, 0 delay, external trigger, and one pulse for every trigger.
:PULSE1:STATE ON <cr> <lf> enables channel A
:PULSE1:POL NORM <cr> <lf> sets polarity to active high
:PULSE:WIDT 0.000025 <cr> <lf>
sets pulse width to 25μs
:PULSE1:DELAY 0 <cr> <lf> sets delay to 0
:PULSE0:MODE SING <cr> <lf> sets system mode to single
shot
:PULSE:EXT:MODE TRIG <cr> <lf> sets system to external trigger
:PULS:EXT:LEV 2.5 <cr> <lf> sets trigger level to 2.5 volts
:PULS:EXT:EDGE RIS <cr> <lf> set to trigger on rising edge
To arm the instrument in external gate mode, use either of the following commands:
:PULSE0:STATE ON <cr> <lf> Arms the instrument
:INST:STATE ON <cr> <lf> Alternate form if T
0
is currently
selected.
A software generated external trigger can be generated by using the following command:
*TRG <cr> <lf> Generates a software external
trigger