Quantum Composers 9250 Series - Manual (Page 41)

9250 Manual Version 1.2 | Quantum Composers
41
:ENable 0/1 or OFF/ON
Turns on/off Bluetooth
module. Disables Bluetooth
transmitter. This state is not
saved and will default to on
when power is cycled.
*Note: Command not
available on units without
Bluetooth option.
:ECHo 0/1 or OFF/ON
Command to enable/disable
the echo function on the
Bluetooth interface. The Echo
function will cause the unit to
repeat the command received
to the PC.
*Note: Command not
available on units without
Bluetooth option.
:MAC ?
Returns the Bluetooth MAC
address.
:AUTorun 0/1 or OFF/ON
When the unit is powered up,
if this command is enabled,
the unit will start pulsing
automatically.
:VERSion ?
Query only. Returns SCPI
version number in the form
YYYY.V for ex. 1999.0
IEEE 488.2 Common Commands
Command: Parameter Range: Notes:
*IDN ?
Query only. Returns model, serial number, firmware version, and FPGA
version numbers.
*RCL 0 - 6 Recalls configuration from specified storage location
*RST RESET. Resets parameters, same as *RCL 0
*SAV 1 - 6 Saves current parameters to desired storage location
*SER ? Serial number query.
*TRG Creates a soft trigger input.
*ARM
Resets all channel counters simultaneously when the channels are in either
single shot or burst mode.
*Note: The system must be in continuous mode (this command is functionally
the same as pressing the Run/Stop button).