Quantum Composers 9250 Series - Manual (Page 37)

9250 Manual Version 1.2 | Quantum Composers
37
9250 SCPI Command Summary
Command Keyword 1 Keyword 2 Keyword 3
Parameter
Range
Notes
:INSTrument The units’ upper level command
keyword.
:CATalog ?
Returns a comma separated list
of the names of all channels.
Example: A two channel unit
would return T
0
, CHA, CHB
:FULL ?
Returns a comma-separated list
of the names of all the channels
and their associated number.
Example: a two channel unit
would return T
0
, 0, CHA, 1, CHB,
2
:COMMands ?
Returns an indentured list of all
valid SCPI commands
:NSELect 0 – 4
Selects a channel using the
numeric value
:SELect T
0
/ CH[A-D]
Selects a channel using the
identifier
:STATe 0/1 or OFF/ON
Enables/Disables the selected
channel output. If no channel
has been selected the command
is applied to T
0.
If T
0
is selected
all outputs are affected.
Enabling T
0
is the same as
pressing the RUN button.
Command Keyword 1 Keyword 2 Keyword 3 Parameter Range Notes
:PULSe[0]
Command to change the
units’ global settings, this is
the same as using the
:SPULse command
:COUNter
Subsystem. Contains
commands to define the
Counter function.
:STATe 0/1 or OFF/ON
Enables/Disables the counter
function
:SOURce T
0
/ CH[A-D] Counter source. Default is T
0.
:CLear Clears the active counter.
:COUNt ?
Reports the clock pulses
output; although in single shot
mode, the trigger pulses input
on the channel will be
displayed.
:STATe 0/1 or OFF/ON
Enables/Disables the output
for all channels. This
command is the same as
pressing the Run/Stop button.