REMKO RXW 261 - Manual (Page 10)

HEATING Mode
In the heating mode, you can heat the room in spring or fall with the
RXS...H. The selected room temperature is set with buttons
▲/▼ in
1 °C increments. If the room temperature is 1 °C below the selected
target temperature, then the indoor unit starts to heat the air in the
room. If the temperature falls by approx. 1.5 °C below the selected room
temperature, then the regulation turns the heater function off. To protect
the compressor, the regulation only turns the heater on again after
a waiting period of 3 minutes.
MODE
HEATING
OPERATION
In dehumidification mode, the target temperature is set to 24 °C. Due
to the low temperature of the refrigerant, the dew point of the air on
the condenser is lower. The excess moisture in the air is condensed by
the vaporiser, the room is dehumidified. The fan speed is permanently
set to the lowest setting in order to achieve a maximum level of
dehumidification. The compressor switches on and off in intervals
between 17°C and 24°C.
DEHUMIDIFICATION MODE
DEHUMIFICATION
MODE MODE
The fan speed can be adjusted with this button. A selection can be made
between low, medium, high and automatic fan speed.
FAN Button
FAN FAN FAN FAN
With this button, the air discharge fins are individually adjusted.
A selection can be made between 5 positions and an oscillating function.
FIN Button
REMKO RXW
10