REMKO RXW 261 - Manual (Page 9)

The time can be programmed by pressing the CLOCK button inside the
battery compartment. “CLOCK“ blinks in the display and the current
time is set via the HR. and MIN. button. Pressing the CLOCK button
again completes the programming, the display no longer blinks.
CLOCK Button
CLOCK HR/MIN CLOCK
MODE Button
Use the MODE button to select between the individual operating modes.
A total of 4 modes are available:
1. Automatic cooling or heating operation
2. Cooling predominant operating mode for summer
3. Dehumification Operating mode for summer or winter
4. Heating
predominant operating mode for winter (only for
RXS...H)
MODE MODE MODE
Automatic Cooling Dehumidification Heating
In automatic mode, the regulation autonomously selects between
heating and cooling operation when the unit is first turned on. A nominal
temperature of 24 °C is preset. The regulating range is between 22 °C
and 26 °C. This can still be increased or decreased with the
▲/▼ buttons
by 1° C.
AUTOMATIC Mode
AUTOMATIC
MODE
In cooling mode, the air in the room is cooled down to the set target
temperature. The desired room temperature is set with buttons
▲/▼ in
1 °C increments. If the room temperature is 0.5 °C above the selected
target temperature, then the indoor unit starts to cool down the air in
the room. If the temperature falls by approx. 1 °C below the adjusted
room temperature, then the regulation turns the cooling function off.
To protect the compressor, the regulation only turns the cooling on again
after a waiting period of 3 minutes.
COOLING Mode
COOLING
OPERATION
MODE
9