REMKO RXW 261 - Manual (Page 7)

2. Cooling mode
In this mode, the warm room
air is cooled to the desired
temperature.
3. Dehumidification mode
In this mode the room is mainly
dehumidified, the adjusted
temperature is retained.
4. Heating mode
(only for RXS...H)
In this mode, the warm air in
the room is warmed up to the
desired temperature.
This mode should not be used
for RXM units (malfunctions
may occur)
"FAN" Button
Press this button to set the
required fan speed. 4 levels
are available: Automatic, high,
medium and low fan speed.
"FINS“ Button
With this button, the desired fin
position can be set. There are
5 positions and an oscillating
function available.
"SLEEP" Button
After pressing this button, the
target temperature in cooling
operation increases within
half an hour automatically by
0.5 °C, in heating operation,
the target temperature is
reduced within one hour by
1 °C.
"SWING" Button
This button directly activates
the oscillating function of the
fins for better air distribution in
the room.
Buttons on the remote control
Buttons on the remote control
"ON/OFF" Button
Press this button to start the
unit.
“TOO HOT“ Button
This button is used to the
desired temperature can be
increased down to 16 °C.
"TOO-COLD" Button
This button is used to the
desired temperature can be
increased up to 31 °C.
"MODUS" Button
Press this button to select the
operating mode. The indoor unit
has 4 modes:
1. Automatic mode
In this mode, the unit works in
cooling or in heating mode.
"TIMER ON“ Button
This button is used to program
the automatic turn on time
of the unit within the next 24
hours.
"TIMER OFF“ Button
This button serves to program
the automatic switch-off time
for the device within the next
24 hours.
"HR" Button
Press this button to set the
hours.
"MIN" Button
Press this button to set the
minutes.
“RESET button“
(in the battery compartment)
Press this button to reset the
remote control to its factory
default configuration.
"CLOCK" Button
(in the battery compartment)
By pressing this button, the
time setting is activated.
“DISPLAY“ Button
With this button, the display is
turned on and off (no influence
on unit function)
7