REMKO RXW 261 - Manual (Page 20)

Electrical connection diagram
Electrical circuit diagram
RXW 261 to 681
Connection RXM 226 to 435
Connection RXS 261H to 681H
Outdoor component Indoor unit Mains cable
Neutral conductor
Phase conductor
Earth conductor
230 V~,
50 Hz,
L1 / N
/ PE
Control conductor Compressor contactor
N
L1
PE
L
N
1
PE
N
L
PE
3
Commissioning
Commissioning should only be
performed by specially trained
personnel and documented
after the certificate has been
issued.
Observe the manuals
for the indoor unit and
outdoor component when
commissioning the entire
system.
NOTE
Functional test for
cooling mode.
1. Switch the supply voltage on.
2. Use the remote control to
turn on the unit and select
the cooling mode, maximum
fan speed and lowest target
temperature.
3. Measure and record all
the required values in the
commissioning report and
check the safety functions.
4. Check the control system
for the unit using the
functions described in the
chapter "Operation". Timer,
temperature setting, fan speeds
and changing to ventilation or
dehumidification mode.
5. Check the correct function
of the condensation pipe by
pouring distilled water into the
condensation tray.
A bottle with a spout is
recommended for pouring the
water into the condensation
tray.
3
1
2
L
N AC-N
FM SM
EXF
4WV
AC-L
COMP
Outdoor component Indoor unit Mains cable
Neutral conductor
Phase conductor
Reverse flow valve
230 V~,
50 Hz,
L1 / N
/ PE
Control conductor Compressor contactor
N
L1
PE
L
N
3
2
3
N
L
2
1
PE
1
PE
Control conductor
Control conductor
Earth conductor
Fan motor
front terminal block
Colour code
WH = white
BU = blue
BN = brown
Display
Receiver
circuit board
Sensor
Vaporiser
Sensor
Air circulation
Vaporiser
fan motor
Swing motor
Transformer
Phase conductor
Neutral conductor
Earth conductor
Liquefier fan
Reverse flow valve
Compressor
REMKO RXW
20