Remko rxw, Operation – REMKO RXW 261 User Manual

Page 6

Advertising
background image

The indoor unit is easy to operate
using an infrared remote control.
This is supplied as standard.
The indoor unit beeps to
acknowledge the correct
transmission of data.
If it is not possible to program
the indoor unit with the remote
control, then it can also be
operated manually.

Manual operation

The indoor units can be put into
operation manually. After the air
inlet screen has been opened,
the inner recessed button can be
pressed and automatic mode can
be activated.
In manual operation, the following
settings apply:

Cooling mode: last setting
Fan speed AUTO
Heating mode: last setting
Fan: AUTO

Press the button on the infra-red
remote control to interrupt manual
operation.

Display on indoor unit

The display lights up according to
the settings.

The infrared remote control
sends the programmed settings
in a distance of up to 6 m to the
receiver of the indoor unit.
A troublefree reception of data is
only possible if the remoter control
is directed to the receiver and no
objects hinder the transmission.

First insert the supplied batteries
(two each, Type AAA) into the
remote control.
To do so, remove the cover on the
battery compartment and insert
the batteries, in correct polarity.
(see marks).

Operation

Problems are shown in code
(see chapter Troubleshooting
and Customer service).

CAUTION

Infrared remote control

Immediately replace flat
batteries with a new set,
otherwise there is a risk of
leakage. It is recommended
that the batteries are removed
if the equipment is shut down
for long periods.

NOTE

max. 6 m

Max. distance 6 m

Display on indoor unit

Timer

Automatic mode

Fan speed

Display

Display of coded

error messages,

room and target

temperature

Cooling mode

Swing operation

Sleep function

Dehumidfiying mode

Temperature unit

Heating mode

REMKO RXW

6

Advertising