RGBLink VSP 1314 User Manual - Manual (Page 49)

5.System Setup and Operation
How to preview input signal source
VSP 1314 User Manual 49
How to preview input signal source
Make sure equipment normal operation. Detail please refer to : How to
make equipment normal operation
Operation as following：
1. The signal of green light output from Program, can check output if
connect monitor or LED screen send card;
2. The signal of yellow light output from Preview, can check output if
connect monitor;
3. The signal of red light can preview switching, can check image at
preview output;
4. System default DVI as Program output,DVI2 and VGA as Preview
output;
5. Schematic diagram 1 switch to Schematic diagram 2,just to press
TAKE.
Schematic diagram 1：
Schematic diagram 2: