RGBLink VSP 1314 User Manual - Manual (Page 52)

5.System Setup and Operation
How to adjust size and position of image
VSP 1314 User Manual 52
4. Press V SIZE/V POS ,light up green light-Width setting, rotate the
adjust knob can adjust the height of image;
5. Press V SIZE/V POS, light up red light-vertical position setting, rotate
the adjust knob can adjust the position of vertical;
Note: The scale height is limited when input CVBS signal, only 288 pixels is achievable.
You can follow the below steps for more choices:
Select "Program" enter into "Program Scale" select "CV3" select "Layer
Setting" select "Scale Enable" and "Layer On" enter into SCALE", then scale the
desired height.
DVI2 Scale HSize <1024>
Scale HPos < 0>
Scale VSize < 768>
Scale VPos < 0>
DVI2 Scale HSize <1024>
Scale HPos < 0>
Scale VSize < 768>
Scale VPos < 0>
DVI2 Scale HSize <1024>
Scale HPos < 0>
Scale VSize < 768>
Scale VPos < 0>