RGBLink VSP 1314 User Manual - Manual (Page 75)

VSP 1314 User Manual 75
Communication Firmware Upgrade
Shut the power device, switch the direction of arrow of the two dial switch
which download IP board to ON state. As shown in figure:
Connect one end of RJ11 download line to RS232 .control Connector of
video processor end access and the other end access PC serial port.
Double-click ，enter into the procedure Connector of Flash
Magic, setting in figure: First, users select the corresponding serial ports,
set baud rate as 115200, choosing device LPC2368 and loading target file
of 100 M IP board of the upgrade program. (hex. File) Then, confirm it
through choosing two
Finally, click ―start‖ button.