Teac CD-RW901MKII - Manual (Page 20)

20
TASCAM CD-RW901MKII
4 − Playback operations
Time display switching
When the TIME key on the front panel or the remote control
is pressed, the time display will switch through several modes
on the display.
• Elapsed track time (no display light indication)
• Remaining track time ( REMAIN is lit in the display)
• Elapsed disc time ( TOTAL is lit in the display)
• Remaining disc time ( TOTAL and REMAIN are lit in the display)
When stopped, the total recording time is shown, regardless of
the status of the TOTAL and REMAIN indicators.
NOTE
In program mode, pressing the TIME key displays the
elapsed and the remaining time of the whole program.
When playing an MP3 disc, elapsed track time is
always displayed, and the TIME key cannot be used.
For details on time display during recording, please
refer to “Time display while recording” on page 27.
Even when power is turned off, the time display mode
setting is retained.
Random playback
In this mode, the unit will play back all the tracks on the disc in
completely random order, regardless of track number.
When stopped, set the mode to display Random or
Mode>Random
. Press the PLAY key and random playback will
begin.
NOTE
Even when the power is turned off, the unit will
remain in Random mode.
Program playback
This function enables playback of selected tracks in any
desired order. Up to 99 tracks can be selected for program
playback.
1. When stopped, set the mode to display Program or
Mode>Program .
2. Use the number keys (0~9) on the remote control
unit to select each desired track for program play-
back, then press the ENTER key.
You can also rotate the MULTI JOG dial to select the
track number and push to enter.
The track number will be entered into the program.
Repeat the above step 2 until the desired program is completed.
As the program is being created, the program number and total
program playing time is revised on the display.
NOTE
If the CLEAR key is pressed, the programmed track
will be deleted from the last.
3. When program setting is completed, press the
PLAY key to begin playback of the tracks in the
programmed order.
NOTE
If the STOP key is pressed without first pressing the
PLAY key, all the program data will be erased.
When stopped, if the playback mode is switched to
another, all the program data will be erased.
The programmed play order is not memorized when
power is turned off.
In this mode, if there are no tracks programed, the
CD-RW901MKII will not start playback.
If an attempt is made to enter more than 100 program
steps, the message PGM Full! appears on the display.
If the total program playing time exceeds 999 min 59
sec, --- : -- appears on the display.
Single-track playback
This function enables playback of just a single track.
1. When stopped, set the mode to display Single or
Mode>Single .
2. Use the SKIP keys or the number keys (0~9) on
the remote control to select the desired track. The
MULTI JOG dial can be used to select the track also.
3. Press the PLAY key to begin playback.
After the selected track finishes, playback stops.