Teac CD-RW901MKII - Manual (Page 30)

30
TASCAM CD-RW901MKII
5 − Recording
Manually divide track
While recording is taking place, press the RECORD key. The
current track number is incremented by one.
For details of automatic track division while recording, see
“Automatic track division” on page 29.
NOTE
According to the “Red Book” (the specification for
audio CDs), a track cannot be less than four seconds
in length, and there can be a maximum of 99 tracks
on an audio CD. Bear these limitations in mind when
adding track divisions.
This operation can not be applied while recording
track 99.
Manually incrementing index numbers
This function allows you to manually assign index numbers .
1. Start recording.
2. Press the
CALL key at the point you want to assign
an index number.
Index XX
where
XX
shows the
number, will be displayed.
NOTE
The maximum index number within a track is 99.
When the unit reaches 99, it will increment the track
number and start assigning index numbers counting
from one.
Automatically Incrementing index numbers
When recording with auto track function, when INDEX
INC is set to on (see “Operation basics” on page 16), the unit
overrides the setting of the automatic track division, and
instead of incrementing track numbers, it increments the
index numbers within a track.
Use the
MULTI JOG dial or MENU (+/-) keys on the remote
control to switch INDEX INC on or off.
Index XX
where
XX
is index numbers will appear on the
display.
NOTE
The maximum index number within a track is 99.
When the unit reaches 99, it will increment the track
number and start assigning index numbers counting
from one.
Automatic track division with trim function
When Auto Track is set to either Level or DD mode, it is
possible to trim the automatic track division point using
A_TRK TRIM option in the REC sub-menu (see “Operation
basics” on page 16). This function allows you to slip the start
time of the track increment forwards or backwards.
NOTE
When Auto Track mode is set to Time, the value set in
Auto Track Trim is ignored.
The available trim value is from -125 through +125 frames.
Use the MULTI JOG dial or MENU (+/-) keys on the remote
control to adjust the trim value.
Rec mute function
The Rec mute function allows instant cut-off of the input
signal, and records four seconds of silence on the disc.
While recording is in progress, press the
REC MUTE key on
the remote control.
The display shows the Rec Mute flashing, the meters stop
displaying the current level and the monitored sound is cut.
After about four seconds, the unit enters record ready mode.
NOTE
This function is only available from the remote
control unit.