Teac CD-GT2 - Manual (Page 11)

IMPORTANT SAFETY INSTRUCTIONS
11 TASCAM CD-GT2
Quick Start Guide—Basic Operation
Let’s start using the unit right away. In this section, we will
teach you the basics, including how to setup the unit, play
a CD, connect your guitar and play along with prerecorded
music.
Preparation
Turn the power on
Remove the battery case cover from the underside of the unit,
and insert four ordinary AA batteries, aligning them with the
+ and – symbols inside the case. (See “Batteries” on page 10.)
Turn the power ON after inserting the batteries.
Press and hold the
POWER switch on the rear of the unit for
about one second. Release it when “
TASCAM
” appears on the
display. Start-up completes after a few seconds and the
TIME
DISPLAY
screen appears.
NOTE
You can also use a PS-P520 AC adapter (sold separately)
for power instead of batteries. Connect the AC adapter to
the DC IN 5V jack on the rear of the unit.
Setting a CD
All the controls for this device are on the CD tray cover.
The
OPEN switch is on the front of the unit. Slide it left and
open the tray cover. Put a CD in the CD tray and press it into
place gently until the disc clicks. Close the tray cover after
setting the CD.
NOTE
The keys cannot be used when the tray cover is open.