Teac CD-GT2 - Manual (Page 29)

IMPORTANT SAFETY INSTRUCTIONS
2 TASCAM CD-GT2
Using guitars and mics
By connecting a guitar or mic to this player, you can mix the
input from the guitar or mic with the CD playback sound. You
can also use the built-in guitar and mic effects for guitar and
singing practice
Setting the input
When shipped from the factory, the GUITAR/MIC IN jack is set
for guitar input. Use the following procedures to set the unit
for mic input.
1
Press the
LEVEL
key to open the
LEVEL
screen.
2 Use the CURSOR ( ¥ ) key to choose
INPUT
(initial
setting is
GUITAR
), and use the VALUE (+) key to set it
to
MIC
.
NOTE
The effects available change according to the
INPUT
setting (See “Using built-in effects” on page 30.).
Adjusting the input level
Use the INPUT volume control to the right of the GUITAR/MIC
IN jack to adjust the input level. Use the input level meter at
the bottom of the
LEVEL
screen as shown on the preceding
page for guidance.
Adjusting the monitoring volume
Use the PHONES VOLUME (+, –) keys to adjust the head-
phones output volume. Follow the same procedure used when
adjusting the playback volume of a CD. (See “Adjusting the
volume” on page 25.)
NOTE
Adjust the volume on the external device when using
an audio system or speakers with built-in amplifiers to
monitor through the
LINE OUT jack. You cannot adjust
the output level of this device’s LINE OUT jack.
Playing along with a CD
This device combines the signal input through the GUITAR/
MIC IN jack and the CD playback signal and outputs this mix
to the PHONES and LINE OUT jacks. In other words, you can
play your guitar or sing through a mic connected to the player
and hear this sound along with the playing CD.