Teac CD-GT2 - Manual (Page 43)

IMPORTANT SAFETY INSTRUCTIONS
 TASCAM CD-GT2
Effect module parameter list
Module Effect Parameter Details Range
Chorus
(
CHO
)
Adds a slightly detuned sound to create a wide, ensem-
ble-like tone. This effect was popular in 70s hard rock
and fusion. DPTH Adjusts the modulation depth 0–30
MIX
Adjusts the amount of the effect 0–20
Tremolo
(
TRM
)
Creates a cyclical variation in the volume. A sound like
a rotary speaker can be achieved by combining it with
delay. SPD Adjusts the speed of the effect. 0–30
MIX Adjusts the amount of the effect 0–20
Vibrato
(
VIB
)
Creates a cyclical variation in the frequency for a regu-
lar pitch variation. SPD Adjusts the speed of the effect. 0–30
MIX Adjusts the amount of the effect 0–20
Autowah
(
WAH
)
Creates a sound like a wah pedal that is great for funky
sounds. Vary your picking force when using this effect. SENS Adjusts sensitivity to picking force 0–30
MIX Adjusts the amount of the effect 0–20
Pitch Shifter
(
PIT
)
Changes the pitch of the input signal and can be used
to create a doubled lead sound, for example. Set
PIT
between 6 and 17, or –6 and –17, for semitone changes.
PIT
Adjusts pitch in semitones (±6–17)
or in smaller intervals (–5 to +5) ±17
MIX Adjusts the amount of the effect 0–20
Reverb
(
REV
)
Creates reflections, like the echoes in a stone church, to
give the sound greater width. Surf rock uses this effect
extensively. TIME Adjusts the reverberation time 0–25
MIX Adjusts the amount of the effect 0–20
Delay
(
DLY
)
Adds echoes to the sound. Adjust the
TIME
and turn the
MIX
level up for a rockabilly sound.
TIME Adjusts the delay time 0–99
MIX Adjusts the amount of the effect 0–20