Teac DP-01 Series Owners Manual - Manual (Page 20)

Assigning inputs
20
TASCAM DP-01 Owner’s Manual
Starting out with your DP-01
Assigning inputs
When we talk about “assigning” inputs, we are talking about linking the sig-
nals from the two inputs to the tracks.
You can record on up to two tracks at a time. This means that the same input
can be assigned to two tracks at the same time (you can’t then use the other
input) or the two inputs can be assigned to different tracks. You can’t assign
both inputs to the same track at the same time.
…
Press and hold the ASSIGN key corresponding to the input signal you
are assigning ( A or B ).
Press and hold
SHIFT and either
of the ASSIGN keys ( A or B ) to
turn the inputs on or off as
shown by the indicator. You may.
turn off unused inputs to reduce
noise.
…
While holding down the ASSIGN key, press the REC key of the track to
which you are assigning the input.
The REC key flashes rapidly.
…
If you want to assign the input to another track, you must first clear
the current assignment (see below), and then re-assign the input.
Note that the REC key of the first track to which you assigned the
input flashes when you hold down the ASSIGN key.
Clearing an assignment Hold down the ASSIGN key to check current
assignments and while holding the ASSIGN key, clear current assign-
ments by pressing a flashing REC key (which then stops flashing).
Figure 1.7: Assigning inputs to tracks
Press and hold
one of the
ASSIGN keys
And then press
one of the 8
REC keys