Move -> paste, Move -> insert, Move -> paste move -> insert – Teac DP-01 Series Owners Manual User Manual
Page 48: About track editing, Advanced techniques
About track editing
48
TASCAM DP-01
Owner’s Manual
Advanced techniques
…
You can change the following values:
Src. Trk
This sets the source track or tracks from which the section is copied.
Choose
1
through
8
to select an individual track. Choose
1/2
,
3/4
,
5/6
or
7/8
etc.
to select a pair of tracks. Choose
1-8
to select all tracks.
Dst. Trk
This sets the destination track or tracks into which the selected sec-
tion is inserted. What you can select here depends on what you have selected
for the source track. If you have selected a single track, you can select tracks
1
through
8
here. If you have selected a pair of tracks (for instance,
1/2
), you can
only select track pairs here. If you have selected all tracks (
1-8
), then
1-8
is the
only option available to you here.
Times
This is the number of times that the selected section is inserted (end-
to-end) in the destination track or tracks. You can set this value from
1
to
99
.
Press
YES
to perform the operation or
NO
to leave this screen.
MOVE -> PASTE
This function takes the section of a track or tracks marked by the IN and OUT
points, and moves it to the chosen track or tracks, starting at the TO point.
After the operation, the selected section of the source between the IN and
OUT points is replaced by silence.
This operation overwrites anything which is already recorded at the destina-
tion. The destination is therefore the same length as it was before the opera-
tion.
…
You can change the following values:
Src. Trk
This sets the source track or tracks from which the section is taken.
Choose
1
through
8
to select an individual track. Choose
1/2
,
3/4
,
5/6
or
7/8
to
select a pair of tracks. Choose
1-8
to select all tracks.
Dst. Trk
This sets the destination track or tracks to which the selected sec-
tion is moved. What you can select here depends on what you have selected
for the source track. If you have selected a single track, you can select tracks
1
through
8
here. If you have selected a pair of tracks (for instance,
1/2
), you can
only select track pairs here. If you have selected all tracks (
1-8
), then
1-8
is the
only option available to you here.
Press
YES
to perform the operation or
NO
to leave this screen.
MOVE -> INSERT
This function takes the section of a track or tracks marked by the IN and OUT
points, and moves it to the chosen track or tracks, inserting it as new material,
starting at the TO point.
After the operation, the selected section of the source between the IN and
OUT points is replaced by silence.
The insert operation adds the selected section as new material to the destina-
tion. Nothing is overwritten on the destination, as any material following the
TO point is moved to the end of the newly-inserted section. The destination
is therefore longer than it was before the operation.
Figure 2.6: Move and paste
OUT
IN
TO
OUT
IN
TO
Figure 2.7: Move and insert
OUT
IN
TO
OUT
IN
TO