Teac DP-01 Series Owners Manual - Manual (Page 32)

Repeat
32
TASCAM DP-01 Owner’s Manual
Advanced techniques
Repeat
Repeat allows you to repeat the playback or auto-punched rehearsal (see
“Rehearsal” on page 29) between the IN and OUT points.
You can’t set these
points when the
REPEAT key is lit.
…
First, set the IN and OUT points at the place where you want the
repeat loop to start and stop (see “IN and OUT marks” on page 26).
…
Press the REPEAT key briefly so that the indicator lights. Playback
starts automatically from the IN point.
…
When the playback reaches the OUT point, playback pauses for a
short while (see “Setting the repeat interval” on page 32) and the
PLAY
indicator flashes before playback starts again, and the PLAY indicator
lights steadily.
…
Turn off the repeat function by pressing REPEAT so that the indicator
goes out.
Repeat auto-punch rehearsal, but not repeat auto-punch recording, is
also possible. If
AUTO PUNCH , RHSL and REPEAT are all lit, pressing
RHSL to go from rehearsal to auto punch recording mode will also
turn off REPEAT .
Setting the repeat interval
You can set the time between repeats up to 9.9 seconds.
This repeat inter-
val allows you to
reposition your hands for a guitar
lick, take a breath for a vocal
phrase, etc. when you are
rehearsing.
…
Press and hold the REPEAT key for about a second, and the screen
shows:
Use the wheel to set the repeat interval from 0.5 seconds to 9.9 sec-
onds in 0.1 second steps.
…
Press REPEAT again briefly to exit the interval setting mode.
A B S 0 0 : 0 2 : 3 4 : 2 1
- - - - - - - - - - - - - - - -
R E P E A T
I N T E R V A L / 1 . 7