Power, Wall mounting – Teo IP Phone 4101 Installation User Manual
Page 11
Installation
13-280135 Rev. K
Page 11
P
P
o
o
w
w
e
e
r
r
The 4101 is compatible with IEEE 802.3af power over Ethernet cabling, utilizing either
power over spare cable pairs (midspan power source) or phantom power (powered
switch/hub port). The phone provides an 802.3af PD Class 2 indication to the power
sourcing equipment and requires a maximum of 5 watts of power.
Power may also be provided an optional local power supply (-PWR5 option, Teo
model 901055).
Connect power after all other connections are complete. If PoE is not provided,
plug the power supply barrel connector into the round jack on the back of the
phone. Connect the power supply to a standard 100-240 VAC, 50-60 Hz power
outlet.
W
W
a
a
l
l
l
l
M
M
o
o
u
u
n
n
t
t
i
i
n
n
g
g
To save space, you can directly hang the phone on a wall or wall plate. You need two
screws that will fit the keyhole slots.
Note: Wall mounting screws are not supplied with the phone.
•
Press the base in the direction shown to release the locking tabs, and then remove
the base.
•
Rotate the base 180°.