Tri Tool 614RBL Thru 636RBL Clamshells - Manual (Page 16)

16
TRI TOOL INC.
92-0480 : Rev. 130916
5.5 INSPECTION OF THE MAIN GEAR
If the Headstock does not run smoothly, even after you make adjustments, inspect
the Main Gear to ensure that chips, dirt, or dust did not damage the gear.
5.6 LUBRICATION OF DRIVE GEAR AND MAIN GEAR
1. Remove the Drive Housing(s).
2. Inspect both the Drive and Main Gears for chips or burrs and clean.
3. Coat the teeth of the Drive and Main Gear with a lubricant that is approved by
Tri Tool Inc., see section 5. 11.
5.7 TOOL BLOCK MAINTENANCE
1. Clean the slide rails, the feed nut, the sprocket assembly and the feed screw.
2. Inspect these parts for damage and replace as required.
MAIN GEAR
DRIVE GEAR
Figure: 5. Main and Drive Gears
SPROCKET ASSY
FEED SCREW
SLIDE RAIL
FEED NUT
TOOL HOLDER
ADJUSTMENT
SLIDE RAIL
Figure: 6. Tool Block Maintenance Areas