Tri Tool 614RBL Thru 636RBL Clamshells - Manual (Page 35)

35
Model 614RBL thru 642RBL Clamshells
92-0480 : Rev. 130916
23. Engage the Tripper Shaft by pushing it to the ‘in’ position.
24. Rotate the Headstock 360° and check the Feed Pin to Sprocket Engagement.
25. Begin to cut the pipe.
26. Loosen the Set Screws holding Tool Bits A, D and E.
27. Slide Tool Bits D and E inward until they make contact with the beveled
surface formed by Tool Bits B and C. Then ensure that Tool Bit A does not
move from its prior position.
28. Complete the preparation profile cut and first sever.
6.10 RESETTING THE TOOL BITS FOR A BLEND
A blend is required to create room for the forward edge of Tool Bits D and E.
Figure: 21. Correct Blend
Tool Block No. 1
Correct depth of cut from Tool
Bits B and C with Tool Bits D
and E.