Tri Tool 614RBL Thru 636RBL Clamshells User Manual
Page 30
30
TRI TOOL INC.
92-0480 : Rev. 130916
6.6 SELECTION AND INSTALLATION OF THE TOOL BIT SET
See section 9 for a description of Tool Bit Sets. This section has the installation
drawings of the Tool Bit Set-Up.
1. Ensure that the wall thickness plus 3/4” (19.0 mm) of Tool Bit protrudes from
the end of the Tool Holder.
2. Tighten the Tool Bit Set Screws.
3. To check that there is adequate radial clearance, do a full rotation of the
Headstock.
4. Check that the Leading Tool Bit contacts the pipe approximately .020”
(.51 mm) to .040” (1.02 mm) before the Trailing Tool Bit.
CAUTION
CAUTION: Do not touch the tool bits with your hands. The tool bits
are very sharp and can cut or puncture your skin. Be sure to use
gloves when you handle tool bits
CAUTION: Do not use dull tool bits or tool bits that are not made by
Tri Tool Inc. If you use these bits the Clamshell may perform poorly.
This constitutes abuse of the equipment and may void the warranty.