Verilink NCC 2130 (880-503285-001) Product Manual - Manual (Page 19)

Verilink NCC 2130 User Manual 3-1
Chapter
3
Configuration
This chapter covers configuring the CSU/DSU portion of the NCC
2130 Node Controller, setting up the controller functions through
the Craft (terminal) interface and use of the front panel
thumbwheel switches.
Using the Craft Interface
To access the Craft interface, connect a terminal or a computer
running a terminal program to the Craft port on the NCC 2130 front
panel.
Verilink NCC
Craft Port
Terminal Setup
Set your terminal parameters to:
Data Rate : 19.2 kbit/s
Word Size : 8 bits
Parity : None
Stop Bits : One
Flow Control: None
The Verilink Craft interface does not assert any control leads.
Verilink provides a "Craft cable" which has an RJ-11 modular
connector at one end and a female DB-25 connector at the other.
Connect the RJ-11 modular connector to the port labeled
CRAFT on
the front of the NCC 2130 module.
The Craft cable pinout is as follows:
Table 3-1 Verilink Craft Cable p/n 458-501788-008
Your computer may have a DB-9 connector, requiring a second
cable or adapter to complete the connection. For this purpose, use
the same type of standard PC AT serial cable as would be used to
connect to an external modem.
DB-25 female RJ-11 modular Usage
pin 2 pin 3 Transmit Data
pin 3 pin 4 Receive Data
pin 7 pin 5 Signal Ground