Westermo IDW-90 - Manual (Page 19)

19 6620-2200
Configuration
All needed configurations and parameter settings are done by the DIP-switches, located
under the top lid of the IDW-90.
DIP-switch settings
Before DIP-switch settings:
Prevent damage to internal electronics from electrostatic discharges (ESD) by
discharging your body to a grounding point (e.g. use of wrist strap)
NOTE DIP-switch alterations are only effective after a power on or commands
“AT**loadsw” and “AT**reset”.
A setting configured by any other method during normal operation, overrides
the DIP-switch setting. However, at power up, the DIP-switch settings have
precedence over the setting configured by any other method.
1
1 1
1
S2 S1
S3 S4
!
Factory settings
ON
1 2 3 4 5 6 7 8
S1
ON
1 2 3 4 5 6 7 8
S2
ON
1 2 3 4 5 6 7 8
S3
ON
1 2 3 4 5 6 7 8
S4
ON
1 2 3 4
S5