Westermo IDW-90 - Manual (Page 29)

29 6620-2200
&F – Restore Factory Configuration
Syntax:
AT&F<n>
Parameters:
<n>
0: Setup all parameter concerning data port.
1:
Setup all parameter including ISDN protocol and msn settings.
H – Disconnect (Hang-Up)
Syntax:
ATH<n>
Parameters:
<n>
0:
The modem will release the line if the modem currently is on-line.
1: If on-hook, the modem will go off-hook and enter command mode.
&K – DTE-DCE flow control
Syntax:
AT&K<n>
Parameters:
<n>
0:
Disables Flow Control (Default).
3: Enables RTS/CTS flow control in data mode.
4: Enables XON/XOFF.
5: Enables RTS/CTS flow control in data and command mode.