Westermo U200 Installation guide - Manual (Page 4)

V4.2
www.westermo.com
U/R/T200 series
- 4 -
1 Introduction
This document describes how to install and configure switches in the T200, R200 or U200
series.
This Operator Manual describes the properties of the T200, R200 and U200 series.
1.1 T200
The T200 is the time synchronization switch series of Westermo. The T200 series has also
full management support including QoS, network redundancy (FRNT protocol), SNMP, IGMP
snooping, VLAN and MAC security. The switches are approved for industrial use.
All chapters in this document are relevant for the T200 series.
Note: Using the time synchronization, SNMP, IGMP snooping, VLAN and MAC security
management features of the T200 series require minimum network knowledge by the user.
1.2 R200
The R200 series contains the same features as the T200 series except for time
synchronization.
All chapters in this document except chapter 5 are relevant for the R200 series.
Note: Using the SNMP, IGMP snooping, VLAN and MAC security management features of
the R200 series require minimum network knowledge by the user.
1.3 U200
The U200 series is an unmanaged switch implementation with QoS support (layer 2 and 3).
The U200 switch series has the same approvals for industrial use as the R200 and T200
series.
All chapters in this document except chapters 3.3.8, 4, 5, and 7 are relevant for the U200
series.