Westermo U200 Installation guide - Manual (Page 8)

V4.2
www.westermo.com
U/R/T200 series
- 8 -
3 Switch Installation and Configuration
3.1 Mounting
3.1.1 DIN rail mounting
The U/R/T200 DIN rail kit is the default mounting kit, and this kit is enclosed in the switch
shipment unless another mounting kit is specified. Both vertical and horizontal mounting is
possible. The DIN rail kit contains the following parts:
- 1 x DIN clips
- 4 x screws
Figure 1 shows vertical and horizontal DIN rail mounting.
Figure 1, DIN rail mounting
Heavy duty DIN clips are also available (improved vibration properties) for horizontal DIN rail
mounting, MOUN0003. This mounting kit must be ordered separately.
3.1.2 19” dual units mounting
The U/R/T200 wall mounting kit, MOUN0009, contains the following parts:
- 2 x short angle brackets
- 4 x nut brackets
- 2 x H – lists
- 4 x curved nuts
- 4 x rack screws
- 4 x rack brackets
- 8 x brackets
- 8 x screws