H3C Technologies H3C SR6600-X - Manual (Page 90)

80
service interface of the router. The management Ethernet port is used only for managing the router and
it has no service processing capabilities such as data forwarding.
Table 32 Management Ethernet port specifications
Item Specification
Connector RJ-45
Interface type Automatic MDI/MDI-X
Frame format
Ethernet_II
Ethernet_SNAP
Interface speed and duplex mode
10 Mbps, half/full-duplex
100 Mbps, half/full-duplex
1000 Mbps, full-duplex
Combo interface
Copper Ethernet port
Table 33 Copper Ethernet port specifications
Item Specification
Connector RJ-45
Interface type Automatic MDI/MDI-X
Frame format
Ethernet_II
Ethernet_SNAP
Interface speed and duplex mode
10 Mbps, half/full-duplex
100 Mbps, half/full-duplex
1000 Mbps, full-duplex
NOTE:
•
The media dependent interface (MDI) standard is typically used on the Ethernet port of network
adapters. The media dependent interface crossover (MDI-X) standard is typically used on hubs or LAN
switches.
• For a combo interface, you can use either the copper port or the fiber port. To switch between the copper
and fiber ports, use the combo enable { copper | fiber } command in interface view.
Fiber Ethernet port
Table 34 Fiber Ethernet port specifications
Item Specification
Connector type LC
Transceiver module type SFP
Interface standards 802.3, 802.3u, and 802.3ab