Configuring traffic policing at the cli, Configuration task list, Configuring traffic policing – H3C Technologies H3C SecPath F1000-E User Manual
Page 350: Figure 232
325
Figure 232 Applying the CAR list to the interface
•
Select GigabitEthernet 0/1 from the Interface Name list.
•
Select Inbound from the Direction list.
•
Enter 1 in the CAR List Index field.
•
Enter 50 in the CIR field.
•
Select the Pass option for Green.
•
Select the Discard option for Red.
•
Click Apply.
Configuring traffic policing at the CLI
Configuration task list
Complete the following tasks to configure traffic policing, traffic shaping, and line rate:
Task Remarks
Configuring traffic policing in policy approach
Configuring traffic
policing in non-policy
approach
Configuring CAR-list-based traffic policing
Configuring ACL-based traffic policing
Configuring traffic policing for all traffic
Configuring traffic policing
Configure traffic policing in either policy approach or non-policy approach.
- H3C SecPath F5000-A5 Firewall H3C SecPath F1000-A-EI H3C SecPath F1000-E-SI H3C SecPath F1000-S-AI H3C SecPath F5000-S Firewall H3C SecPath F5000-C Firewall H3C SecPath F100-C-SI H3C SecPath F1000-C-SI H3C SecPath F100-A-SI H3C SecBlade FW Cards H3C SecBlade FW Enhanced Cards H3C SecPath U200-A U200-M U200-S H3C SecPath U200-CA U200-CM U200-CS H3C SecBlade LB Cards H3C SecPath L1000-A Load Balancer