Adding a test tunnel – H3C Technologies H3C Intelligent Management Center User Manual
Page 67
58
The following buttons are available:
•
Add—Adds a test tunnel (see "
•
Delete—Deletes test tunnels (see "
.")
•
Refresh—Refreshes the page with the latest test tunnel list.
Test tunnel list contents
•
Latest Test Result—Result from the most recent test. Options are:
{
High
{
Middle
{
Low
{
Faulty
{
Not Tested
•
Source Device Name—Name of the source device. Click the device name to view device
details.
•
Source Device Model—Model of the source device.
•
Source IP—IP address of the source device.
•
Destination Device Name—Name of the destination device. Click the device name to view
device details.
•
Destination Device Model—Model of the destination device.
•
Destination IP—IP address of the destination device.
•
Modify—Click the Modify icon
to modify the IP addresses of the source and destination
devices (see "
Adding a test tunnel
1.
Access the Test Tunnels page.
2.
Click Add.
The Add Test Tunnel page appears.
3.
Click Select next to the Source Device Name field to select a source device from the IMC Enterprise
and Standard platform.
For more information about selecting devices, see HP Intelligent Management Center v7.0
Enterprise and Standard Platform Administrator Guide.
After a source device is selected from the IMC Enterprise and Standard platform, the Source IP field
is automatically populated with interface IP addresses of the device. A device can have multiple
interface IP addresses, from which one can be selected as the device IP address
4.
Select a destination device by using the same method.
5.
Click OK.
NOTE:
The selected source device and destination device must both support NQA.