Grass Valley iTX Output Server 2 v.2.6 - Manual (Page 73)

67
iTX Output Server 2
Channel Configuration Guide
Downgrading from Output Server 2 to Output Server 1
It is possible to downgrade from Output Server 2, back to Output Server 1, if required. iTX
stores the configuration data for both versions of the service separately, so that after rolling
back to Output Server 1 you will be reverted to its own configuration settings.
IMPORTANT
• Output Server 1 does not support dual channel or simulcast broadcasting.
If you require this functionality you must use Output Server 2.
• Before reinstalling Output Server 1, you must uninstall and delete the
v12.1.0.107 AJA video card drivers on your playout server, then reinstall
v7.4.0.49 drivers.
To downgrade from Output Server 2 back to Output Server 1:
1 Access and open the iTX Installer files.
2 Right-click the Setup.exe file and select Run as administrator .
3 Click SELECT SOFTWARE.
4 Expand the Playout section
5 Uncheck Output Server 2
6 Click OK to return to the iTX Installer dialog.
7 Click CONTINUE. Allow Output Server 2 to uninstall completely.
8 Click FINISH to complete the uninstall.
9 Uninstall and delete the v12.1.0.107 AJA video card on your playout server, then
reinstall v7.4.0.49. These can be found in the Drivers folder of the iTX Suite.
10 Restart the iTX Installer.
11 Click SELECT SOFTWARE.
12 Expand the Playout section
13 Check Output Server 1.
14 Click OK to return to the iTX Installer dialog.
15 Click CONTINUE to reinstall Output Server 1.
16 Finish the installation as normal.