Grass Valley JEP Series v.1.3.0 - Manual (Page 53)

JEP Series — Installation Manual 53
Configuration - Jupiter System
Serial System
In this application the JEP-100 is operated in Serial mode, with the LAN
connection used only for software upgrade purposes.. (
Figure 29 )
Serial
Ports
100baseT Jupi
ter LAN
16 JEP-100s per
serial bus maximum
IP switch
Serial
buses
Panel ID
02"
Panel ID
01"
Panel ID
16"
Panel ID
01"
Jupiter
File Server
CM-4000 System Controller
CM1"
JEP1"
JEP2"
JEP16"
JEP17"
Figure 29. Serial System Naming and Addressing (Example)
Serial Protocol Table Entries
When a JEP-100 is connected to a CM-4000 or CM-4400 serial port (and
operated in Serial mode), the panel must be configured for “ESCP” protocol
using the Serial Protocol table. The Baud rate should be set at 115K.